Function:
The variants release one or two analog signals or an analog signal and PWM-signal. They differ also in lever geometry, the calibration angle, the programmed characteristics, and the lever guidance. On the test stand, the sensors are programmed at first then followed by a 100% inspection. The giver signals are measured over a 370° rotation and evaluated afterwards.
New is the parallel programing and verification of two socalled dies of a sensor.
Components:
The software of this appliance is written in LabVIEW 8.5.1. The measurement instrumentation used, besides the MCD hardware, are NI-Motion and DAQ components by NI.
