The new version 3.0 can selectively be activated via USB, (serial device), RS232 or RS485. Each interface can be used as master converter from USB to RS232 and to RS485 respectively. 4 inputs as a trigger up to 10kHz. 2 outputs as PWM generator from 10 to 250Hz, 0 to 100%. 4xADW inputs, 0 to 10V, 10 bit, software kalibrated. Now the module can trigger on 8 different samples. Baud rate via Dip-Switch adjustable 19,2kBd / 57,6kBd / 115,2kBd. Seperated lead of operating voltage for output 1 to 8, output 9 to 16, supply of control electronics. Consequently the operating voltage can be switched off at emergency shut down. Outputs can be supplied with different voltage, e.g. 12V and 24V. Control of serial communication via CRC-check.
Available at the end of May 2006
